Re: Did I break it?
inside the engine case where the shaft goes from the clutch to the sprocket there is ONE big spring that is your clutchspring there is one small spring behide the pressure plate of the clutch that sort of helps hold the pressure plate off the clutch pads when the clutch lever is pulled. so ther is only 2 springs on the whole system that big spring is in between the 2 bearing that the mainshaft rides on . I have a post on adjusting the clutch so if you go to the clasic posts you should be able to find out how to adjust the clutch.
go to the classic posts on the second page about the middle of all the posts is motor bicycle clutch or someting like that anyway it should get you going on how to adjust the clutch.
Last edited by Norman; 08-21-2008 at 08:35 PM.