View Single Post
Old 04-29-2011, 01:00 PM
dag_29307's Avatar
dag_29307 dag_29307 is offline
Motorized Bicycle Elite Member
Join Date: Jul 2009
Location: Enoree, Sc.
Posts: 296
Default Re: Mini keg mock up

Ok here is the update to the mini keg build...I went looking for something to use as a filler neck and cap when I came across my wife's aluminum water bottle, I peeled the brass screw fitting out of the top of the bottle and JB Welded it to the top of the keg. and waited for that to harden when it was done I drilled through the keg and used a dremel to smooth out the inner edges (careful of the threads). then I JB Welded a 1/4" brass fitting to the bottom of the keg over a hole I drilled there. Now I just have to get some hose and clamps and I'll have this mounted on my wooden keg carrier. I also made a place for the 6V batt. that's gonna run my lights. Once I get some $$ I'll buy a NT carb. and I'll be motoring again. Until later, Ride safe guys.
Attached Images
File Type: jpg P290411_13.02.jpg (65.0 KB, 214 views)
File Type: jpg P290411_13.22.jpg (41.5 KB, 210 views)
File Type: jpg P290411_13.45.jpg (72.6 KB, 414 views)
File Type: jpg P290411_13.46.jpg (62.7 KB, 259 views)
File Type: jpg P290411_13.23.jpg (48.1 KB, 251 views)
Hope it Helps. I am also a proud member of the 20 MPH. club

Last edited by dag_29307; 04-29-2011 at 01:04 PM. Reason: Pics
Reply With Quote