View Single Post
Old 04-18-2011, 07:28 AM
heyscuba's Avatar
heyscuba heyscuba is offline
Motorized Bicycle Senior Member
Join Date: Jan 2011
Location: st. louis, missouri
Posts: 64
Default Re: Cylinder bolt problems about to throw it away

when I 1st worked on my motor one stud came out with the acorn nut provided, I had a hard time getting it back in, so I actually ground 2 flat spots on the center of the stud (between the threaded area's) and used a small wrench to tighten it down in there,...
Probably no the best idea, but it worked and it's not like that bolt is holding up an I beam or anything,...
"Don't let your meat loaf,...."
see my bar trick vids at
Reply With Quote