View Single Post
Old 04-12-2011, 10:53 PM
culvercityclassic's Avatar
culvercityclassic culvercityclassic is offline
Motorized Bicycle Elite Member
Join Date: Sep 2009
Location: Culver City, Ca
Posts: 2,902
Default Re: Custom Frame For Thumper Motor

I found little time to work on the frame, the design and figuring out the lay-out and notching angels are a _itch. The bottom drop loop will be 1 ˝ tubing to hold the bracket for the beast of a motor.

I have been studying lots of bikes but always fall back to Rooke Customs; if you look at my past bikes you can see how I like the tanks. Rooke Rules

Not sure how much I will get done this week due to the death race; I need to take my

26 incher…I will weld that project for you no problem, I have the metal too.

I Ride Customs…The tubing roller is OK for the price, don’t expect miracles from it. Read Pats post.
BTW: I am also chevelle68 on Rat Rod Bikes. I sent you the PM
Attached Images
File Type: jpg P4120045_01.JPG (364.3 KB, 854 views)
File Type: jpg P4120049_01.JPG (353.5 KB, 540 views)
File Type: jpg P4120050_01.JPG (399.9 KB, 424 views)
File Type: jpg P4120052_01.JPG (370.6 KB, 492 views)
Reply With Quote