View Single Post
Old 08-12-2008, 08:41 PM
Nomad Nomad is offline
Motorized Bicycle Elite Member
Join Date: Aug 2008
Location: U.S.A.
Posts: 188
Smile Almost ready to fire it up..

Well, I got my Boygofast kit yesterday and proceeded to install it. I will admit there is a "learning curve" to installing one of these motors. My bike has a 1 1/2" lower tube which presented a problem for me, I used many tips that I read on this forum, such as using a chain in the gas tank to clean it, the front mount I made is similar to one I saw on here, and may eventually change it to one more efficient. Tomorrow I will attempt to fire it up, and I'll pick up the pieces that fall off

It was fun assembling it, but at times a little frustrating too. I figure the next one will be quicker and easier, I have a few bolts and nuts with washers that I have no idea where they are supposed to go. As expected the instruction manual us useless, But I have no problem figuring out where things are supposed to go (except for those bolts and nuts). LOL...
I will post a follow up after I start it and will no doubt have questions for "help me".....


P.S. thanks to all who posted the tips that I
found so helpful..
Attached Images
File Type: jpg Picture017.jpg (19.1 KB, 63 views)
File Type: jpg Picture019.jpg (28.8 KB, 73 views)
File Type: jpg Picture018.jpg (19.2 KB, 58 views)
File Type: jpg Picture020.jpg (33.7 KB, 70 views)
File Type: jpg Picture022.jpg (29.4 KB, 87 views)
Reply With Quote