View Single Post
Old 02-09-2011, 01:35 AM
bitsnpieces bitsnpieces is offline
Motorized Bicycle Elite Member
Join Date: Dec 2010
Location: Melbourne, AUS
Posts: 195
Default Re: what did you do to your motor bike today?

I tightened the chain a little more to prevent unnecessary slack, and hopefully not too tight (haven't tested my bike yet)

Tried to bend the rear wheel as straight as possible as one section of it is was crocked.

Filed off the bit that the chain was grinding against on the clutch actuator cover to prevent the chain from hitting it and making too much noise

Took the gasket linings from old engine to fit to this one since it didn't have any

Took the 200w plate from old engine and put it onto new one so it has an (un)official plate which says it is 200w with the manufacturer and all on it.
Reply With Quote