Thread: Wolverines Bike
View Single Post
Old 08-03-2008, 09:59 PM
wolverine wolverine is offline
Motorized Bicycle Newbie
Join Date: Jul 2008
Posts: 19
Default Re: Wolverines Bike

The exhaust wasn't that difficult to make. Just used electrical conduit and a conduit bender. Made the flange at engine out of 1/4 plate steel and mig welded them together . Had to heat and tweak the pipe to fit, but a couple hours and it was done. Had to lower the kick stand mount with a spacer to clear the pipe. I like it , the air intake makes more noise than the exhaust.
Reply With Quote