View Single Post
Old 01-21-2011, 01:15 PM
hayneseeee hayneseeee is offline
Motorized Bicycle Newbie
Join Date: Jan 2010
Location: punta gorda,fl
Posts: 11
Default engine mounts and offsets

Hi from sunny Punta Gorda FL working on my first build. I'm mounting the GrubeeGT5 on a Micargi Pantera. Right off the bat my chain is too close to the tire(2.125). I am using a Creative Eng sprocket on the rear wheel. Questions 1) has anyone used the engine mounts by AMPT with the 3/8 or 5/8 offset? They are pricey but after viewing all the other set ups on all your posts it would cost just as much to have something made. 2) where do you measure your two sprockets to see how they align. I used a square and measured from the sprockets on the pedal chain side. 3)What is a Felt frame? I enjoy reading all the posts it is helpful for us newbees? Hopefully I'll get alot of your good advice on your replies. THANKS
Reply With Quote