View Single Post
Old 07-30-2008, 08:16 PM
Bikeguy Joe Bikeguy Joe is offline
Godfather of Motorized Bicycles
Join Date: Jan 2008
Location: up north now
Posts: 11,531
Default Re: Need Clutch help!!

Bolt the motor down tight and then run your cable per the instructions. The arm is hard to move the first couple of times sometimes. Put a small pipe over it or use a pair of lock pliers on the end of it and push it over a few times. Lubing the pivot point inside the case helps a lot. (you can shoot some oil in there at the end of the sprocket where the rod is.)

Once it's all hooked up adjust the cable housing at the handle all the way IN. Adjust the cable as tight as you can get it at the motor end, then wind the adjust OUT at the lever end until there is no play at the lever.
Reply With Quote