View Single Post
Old 07-29-2008, 08:09 PM
MarcPhotoMan MarcPhotoMan is offline
Motorized Bicycle Elite Member
Join Date: May 2008
Location: Montreal, Canada
Posts: 258
Default Re: I need help with this one!

I sprayed it with just water and spray around the carb where ut connects to the motor. It does not bog down. took the carb off the manifold nothing is stuck,

Removed the jet and compared it to the jet from the original carb they are totally different,

The new one on the left has a smaller holeat the top and hole on the bottom Looks smaller and rounder . The old jet looks like it was drilled and soldered I never driled or solder it, and the new needle is more tapered also the new that the old one.

I hope that is the reason for the difference in the needle setting.

The bike performed very well to and from work I will seal it up and check for vapor leaks again.

I seem to have more power at the lower end an the uper end with this carb
I need to get a speedometer to see what kind of speed i am getting.
see my pics in the next post

All the help was very much appreciated!

Last edited by MarcPhotoMan; 07-29-2008 at 09:23 PM.
Reply With Quote