View Single Post
Old 11-07-2010, 12:39 PM
Eric2.0 Eric2.0 is offline
Motorized Bicycle Elite Member
Join Date: Sep 2010
Location: NY
Posts: 242
Default Re: Rear sprocket/rag joint position.

Well looks like the dished side is best on the outside.

New problem!

I got the sprocket on well and then went to put the axle and bearings back in the hub. Everything was smooth, but the bearing cap(on the left side is to big to go through the hole in the sprocket therefor I cannot get the bearing seated properly. Looks like I have to hone out the hole in the sprocket so the bearing cap will fit through it.

I could put the hub in first then the sprocket on top of it, but I don't think it will work and would make bearing maintenance a little harder.
Reply With Quote