View Single Post
Old 10-27-2010, 01:33 AM
athIetichunta athIetichunta is offline
Motorized Bicycle Newbie
Join Date: Oct 2010
Location: Weston Fl
Posts: 3
Default Re: 4g belt drive slipping like crazy at 75% and over. Do you know whats wrong?

Sry. I'm havign account problems.

Here's a revise of my last post.

Well I figured out how to adjust the belt, but that didn't do much of anything. I loosened it as much as possible and it didn't seem to make a difference, then I tightened it as I could, and same result.

Its not really the throttle that makes it slip. from a dead start it has alot of power and takes right off and has very good acceleration, but when the bike gets to a certain speed any more throttle will just make it vibrate like crazy and give no power to the back wheels.

This really sucks ): ..


I just tightend the clutch, didn't do anything.

Reved the bike stationary at 75@ throttle to see if belt was slipping, it wasn't.

If i give it a 20/40% throttle. As it accelerates its fine, but as it starts to gradually reach a higher speed the engine will start to rev louder and vibrate alot more while giving less and less power to the wheels, and when you give it more throttle it begins to vibrates and rev so loud its unbearable.
Reply With Quote