View Single Post
Old 07-26-2008, 12:52 AM
Dave31's Avatar
Dave31 Dave31 is offline
Super Moderator
Join Date: Mar 2008
Location: Old Pueblo,Arizona
Posts: 11,118
Default Re: ***help With Dax Install, Part 2***

Dax does have a installation manual on his site...well I've got time here you go....from Dax

Remove the cap and all parts

Place needle into center of carb slide and then put flat washer with groove on top of needle making sure you have the groove lined up with the groove in the carb slide

Install cable to plastic grip, then thread this end through the carb cap and spring

Compress spring and load cable into the end of the slide.Put the entire lenght of the cable into the slide, then release the spring inside the carb slide and allowing the spring to push down the washer and holding the needle down

Reply With Quote