View Single Post
Old 09-30-2010, 04:14 PM
fishguts's Avatar
fishguts fishguts is offline
Motorized Bicycle Elite Member
Join Date: Sep 2010
Location: southeastern MA
Posts: 313
Default Re: AMF Cruiser for motor project

Originally Posted by darkhawk22 View Post
I made it up out of PVC, if it works then great if not then I'll go with Copper. It's sealed internally with the Blue PVC glue and seal all on all the joints. Outer shell is sealed with JB Weld and Seal All. Then there are three coats of flat black Plastic Paint from Rustoleum, then three coats of Wagon Red, then two coats of clear. So far it's only been tested to be air tight. The trick will be to see how well it holds up to Gas/oil mixture.

That's intriguing ... what did you use for a filler/cap? And where did you get PVC sheet stock?

Nice job!
Reply With Quote