Re: Home made flower nut
Thanks guys, glad you like it.
killerkanuck, since my original flower nut was defective when I got the kit I never got a chance to run it out of the box in its original state so I can't compare. Also, since the cup and nut are centered, the only thing that might throw the balance out is the sheetmetal bracket and the set screw, although the sheetmetal piece weighs no more than the set screw itself which is the original flower nut screw and that screw is off center to begin with. I might make another piece and extend the 2 fingers out a little more past the nut to balance the piece out. I figure it won't make a noticeable difference anyhow. *hoping*
McGyver could fix that with bubble gum.
Last edited by meowy84; 09-08-2010 at 09:12 AM.