View Single Post
Old 09-05-2010, 11:47 AM
KCvale KCvale is offline
Motorized Bicycle Elite Member
Join Date: Feb 2010
Location: Phoenix,AZ
Posts: 3,547
Default Re: Schwinn Delmar Front Engine Mount Size?

Well, the Delamr is a steel frame and the front tube is just a little to fat to let the extended studs by just like this moon dog below and couple others I have built.

You can just give the tube a little squeeze (channel locks, C-clap, etc), just enough to let the extended studs by.

Then just take a grinder to the second mounting block and grind off some of the inside at the opening of the U on both sides to where the stud holes are, clear into them if you want.

It gives a nice clean solid mount with the parts on hand ;-}
KC's Krusiers Builds
Reply With Quote