View Single Post
Old 08-16-2010, 10:35 PM
chainmaker's Avatar
chainmaker chainmaker is offline
Motorized Bicycle Elite Member
Join Date: Jan 2010
Location: Ma USA
Posts: 2,597
Default MM intake and clutch arm

I just started installing My kit (zb80) I have a M.M. intake but the clutch arm hits the carb not allowing the arm to be pulled all the way in. Pirates site says" Use of this intake will require that you remove the clutch Line Bolt and cut off a 1/4 inch of thread. Then replace." I am guessing the clutch line bolt is the one that the cable feeds through but I dont see how this will allow the arm full movement, anyone encountered this ? any suggestions?
Thanks in advance

__________________ - The Ultimate Users Guide
Reply With Quote