View Single Post
Old 07-19-2008, 07:06 AM
ADAS1223 ADAS1223 is offline
Motorized Bicycle Newbie
Join Date: Jul 2008
Location: CT, USA
Posts: 7
Default Re: Crammed an 80cc onto my BMX!!!

Originally Posted by Saddletramp1200 View Post
If you can you might think about welding some square stock where the frame is cut from the crown to the bottom tube. Would keep the crown from flexing but then I don't know.
Watch the boys with that motor so close! Later Tramp
Thanks for the tip saddle! I was thinking of just welding a triangle support on the corner of the frame and the seatpost tube thing. The motor is actually a good distance from the payload just gotta keep the WOT to a minimum and those knees apart ..i also added a kick stand and replaced my 2 missing bolts on the sprocket haha (did anyone notice?)
Reply With Quote