View Single Post
Old 08-04-2010, 12:27 AM
sportscarpat's Avatar
sportscarpat sportscarpat is offline
Bonneville Bomber the Salt Flat record breaker
Join Date: Jun 2009
Location: california
Posts: 1,631
Default Re: VMB Monarch Fork Question

I do not run disk brakes so I have not had an interference issue. I flip the plates to the outside of the forks to establish a 110mm hub spacing. I do not drill out the fork ends. This allows the shoulder bolt to bottom out like the original Monark design. From Norms picture it looks as though the disk would interfer with the nylock nuts the way I set them up. Looks like you need to do it Norms way if your using his bracket and disk brake.

Last edited by sportscarpat; 08-04-2010 at 12:34 AM.
Reply With Quote