View Single Post
Old 08-01-2010, 11:42 AM
2door's Avatar
2door 2door is offline
Super Moderator
Join Date: Sep 2008
Location: Littleton, Colorado
Posts: 16,222
Default Re: Badge removal/installation

Carefully, very carefully drill the rivet heads off. Don't rush the job and use a drill bit about half the diameter of the rivet head. A center punch will make it easier to center the drill on the rivet head. Most of the time the head will pop off when the drill goes through it then a small punch can be used to drive the rivet out. It is important to use a drill bit smaller than the head. The shank of the rivet will be about half the diameter of the head as a rule. Good luck. Let us know how you do.
Age and Treachery Will Always Triumph
Over Youth and Skill & "Charlie Don't Ride"

Last edited by 2door; 08-01-2010 at 08:58 PM.
Reply With Quote