Originally Posted by Venice Motor Bikes
Here's what I do... I redrill the holes in the fork legs to the same size as the holes in the dropouts. Then move the dropouts to the outside of the fork legs & put the shoulder bolts through from the inside so that the nylock nuts are on the out side of the fork legs & throw away the large spacer washers
. I also leave the bolts just loose enough the let the suspension work freely.
If you still need a little extra room for the wheel?, just bend the fork legs apart a bit.
This pic doesn't fully show everything, but you can get the picture.
Nice, I may have to give that a try, (after measuring to make sure even that will clear the spokes).