Thread: Clutch?
View Single Post
Old 06-30-2010, 01:51 PM
FlyingHorse87 FlyingHorse87 is offline
Motorized Bicycle Member
Join Date: Jun 2010
Location: Jeannette, PA
Posts: 24
Default Re: Clutch?

Make sure the clutch cable is pulled very tight before tightening the wire clip. Push the clutch arm back with the cable fed through with one hand and hold it, then slide the clip on and tighten it. The clutch action is alot heavier than expected. I just installed my first engine kit and had the same problem, after the first few runs adjust the clip again because the clutch will start grabbing earlier.

Last edited by FlyingHorse87; 06-30-2010 at 09:13 PM.
Reply With Quote