View Single Post
Old 06-23-2010, 12:32 PM
kicking kicking is offline
Motorized Bicycle Elite Member
Join Date: Apr 2010
Location: mississippi
Posts: 403
Question permatex ?

Originally Posted by bairdco View Post
here's another one for putting holes in gaskets;

find a bolt a little larger than the hole you need.

put gasket on hard surface, like a smooth concrete floor or the flat part of your vice.

center the bolt over the spot you need the hole.

whack the bolt with a hammer.

if you look at most bolts, at the end of the threads it's usually indented a bit, so it'll cut right through the gasket and leave a perfect hole.
I was wondering on gaskets , would permatex be an good idea or bad idea ?
Reply With Quote