View Single Post
Old 06-21-2010, 04:43 AM
worksmanFL worksmanFL is offline
Motorized Bicycle Elite Member
Join Date: May 2010
Location: Palm Coast, FL
Posts: 580
Default Re: my first build-cranbrook

Hi All,

Real good looking Cranbrooks!
I too am building my first Cranbrook MB.

Question please?
How did you install your rag joint sprocket?

I want a clean, "unbutchered" install.

I'm going to talk to some local machine shops and get a quote on expanding the inner edge of the center of the sprocket by 3/8".

This will leave about 5/16" gap between the sprocket and the end cap, allowing for 1/2" "possible/allowable - normal?" sprocket movement?

This will clear the end dust cap and the bolts should be flush with the metal moon rings, not half on and half off within the center sprocket hole.

Thank you for your responses.

Last edited by worksmanFL; 06-21-2010 at 04:46 AM. Reason: added comments
Reply With Quote