View Single Post
Old 06-20-2010, 12:33 AM
corgi1's Avatar
corgi1 corgi1 is offline
Motorized Bicycle Elite Member
Join Date: Aug 2009
Location: KCMO
Posts: 2,282
Default Re: Anyone making machined motor mounts (Like Ridley 2-stroke) for Huasheng 4 stroke?

Do you think this is possible,,,,,,,,,, I have a question too,I just got a lucky buy off craig's list,80 cc on a mountain bike frame today and I would like to change the angle of the motor,,,so,,if the frame and motor mount were covered in plastic wrap could I use some of that 2 part (hardening putty)to press between the motor and frame(with the motor level) and let it harden,so that the motor would have shims the correct angle to hold it solid to the frame tubes,,,,I would do the same for the steel clamps so the bolts would pull tight in a straight line,,,
Reply With Quote