View Single Post
Old 06-12-2010, 04:01 PM
2door's Avatar
2door 2door is offline
Super Moderator
Join Date: Sep 2008
Location: Littleton, Colorado
Posts: 16,218
Default Re: clutch shaft bearing "is it important ?"

If you had the clutch actuator cover, left side of engine, off then that bearing is probably the one that goes in the center hole in the drive sprocket. There is a steel pin also. The bearing goes in first then the pin. Both of those parts should have enough grease on them to keep them from falling out easily. If they are dry, lube them and the actuator cam inside the cover before reassembling.
Age and Treachery Will Always Triumph
Over Youth and Skill & "Charlie Don't Ride"

Last edited by 2door; 06-12-2010 at 04:04 PM.
Reply With Quote