View Single Post
Old 06-06-2010, 08:36 PM
dag_29307's Avatar
dag_29307 dag_29307 is offline
Motorized Bicycle Elite Member
Join Date: Jul 2009
Location: Enoree, Sc.
Posts: 296
Default Re: Clutch help needed!!!!

I'm inclined to give the same advice as Bikeguy Joe. I would try filling the hole closed and re-drilling and tap it. If you can't braze you could try using Alumiweld. That stuff is great and it works with only using a propane torch. I have also used this stuff...

Aluminum welding repair rods, weld any aluminum metal by using a Propane Torch - Alumaweld

Marine Tex, epoxy resin, adhesives, silicone grease, engine treatment, cleaner, repair, bond, fill, seal, fiberglass, aluminum, plastics, Starboard, wood

Never for my bike but on other stuff and it hardens like steel I have never tried tapping it but you could give it a shot.
Hope it Helps. I am also a proud member of the 20 MPH. club
Reply With Quote