View Single Post
Old 06-06-2010, 07:52 PM
nolan_speed nolan_speed is offline
Motorized Bicycle Member
Join Date: May 2010
Location: Seattle, WA
Posts: 30
Default Re: blueprinting not hotrodding

I pulled both gaskets off then set the head back on the cylinder (but didn't bolt it down) and spun the engine over a few times and nothing made contact. I put just one of the gaskets back on and it runs much better now with a little more compression. Stock I think they only have like 6:1 or something which is super low, a little more compression shouldn't hurt anything.
Reply With Quote