View Single Post
Old 05-17-2010, 09:33 PM
MadC MadC is offline
Motorized Bicycle Senior Member
Join Date: May 2010
Location: Toronto
Posts: 69
Default Re: First Cruiser build - Open to comments

Originally Posted by View Post
A little tip for the wiring... If you use zip ties, don’t tighten too much ... I prefer running the clutch and the throttle cables through the nice gaps between the gas tank mounting bolts and the frame.... holds it securely, and puts them in a nice approach angle to where they go on the motor.... also not tight, so they function.....

... also might want to tighten up your chain tensioner wheel (chain “looks” loose)... i like to drill a small 3/16” hole through the tensioner and the frame to keep it from moving...

LOOKS GOOD.... hope this stuff helped
It sure did, I tightened the tensioner and I'll redo the ties, I did do some tie downs
Reply With Quote