Re: Couple questions ... Idle screw, fine-tuning
Anks that's a good tip. Big problems last night though. Went to show it off to the fam cause it was finally running really good. Lost the idle screw on the way over. That sucks. I thought that was for motor speed but I guess it's the air mixture screw. So while I thought I was turning the speed down I was actually letting more air in and makng it rev higher(?is that correct? More air higher rev?) I think that was why I didn't notice any change when I was slowly turning it left. It was already running on full air. Can wait to see how it's gonna run now I know it needed less air. It already seemed perfect. Ordering a new scre off the Internet. Anyone know if I can find those at a hardware store or small motor shop?