View Single Post
Old 04-25-2010, 11:28 AM
NunyaBidness's Avatar
NunyaBidness NunyaBidness is offline
Motorized Bicycle Elite Member
Join Date: Jun 2008
Location: memphis tn
Posts: 1,061
Default Re: Bucking bar to camshaft problem.

I have a similar problem with my clutch. The ball bearing grinds a divot in the end of the little pin and I have to adjust my cable a little tighter. Eventually it will grind the pin too much and I have to either turn the pin around or cut another from a piece of steel rod that I got just for this purpose. Grease does not work to fix the problem and I have been unable to find a fix for this problem yet either.
"I would rather be exposed to the inconveniences attending too much liberty than to those attending too small a degree of it." - Thomas Jefferson

Last edited by NunyaBidness; 04-25-2010 at 11:29 AM. Reason: failure to proof read before posting results in much editing
Reply With Quote