View Single Post
Old 06-30-2008, 10:50 AM
Wheel Rush Wheel Rush is offline
Motorized Bicycle Elite Member
Join Date: Jun 2008
Posts: 209
Default Re: Squeal in Front Chain Sprocket

OK got the ball out and stuck a finger tip full of wheel bearing grease in there and replaced the ball replaced the shaft lubed and will grease the arm and recover.

Now the upper clutch cable holder entrance, how much lub goes here, like I don't want to have an over lube stuffed in there when it has no place to go but through the clutch seals. shall I put a few drops of engine oil in there with some bearing grease or what ?

What about the other side of the clutch assembly, . . with the cover off, . showing one large gear and one small gear, should these receive any lube while I'm at it ?

Last edited by Wheel Rush; 06-30-2008 at 12:14 PM. Reason: Additional Question
Reply With Quote