View Single Post
Old 04-18-2010, 11:52 PM
abikerider's Avatar
abikerider abikerider is offline
Motorized Bicycle Elite Member
Join Date: Jul 2008
Location: Sacramento, CA
Posts: 219
Default Re: 49cc 4G T Belt Drive ??????

Originally Posted by recumbentbill View Post
I just installed a 4G on my huffy cranbrook cruiser. Here is my 2cents. Firstly there are two g4 drives.The Hausheng and the honda. The Hausheng is wider, Has bearings in the clutch bell housing vers the honda bushing on the clutch bell housing. A output shaft with ten tooth sprocket is offered for both units. Beware--- the Hausheng shaft and the honda shaft are not one in the same. the hausheng's shaft bearings are spaced further apart than the honda unit. I found this out the hard way when I ordered the honda unit with the 10 tooth non free wheel sprocket. I assumed the correct shaft would be with the order. NOT... The dealer was not aware of the differences between the two units. Also my dealer doesn't carry the honda G4 10 tooth solid output shaft[Bummer].
Hi, just wondering if you ever found a dealer that does carry the G4 output shaft for the 10 tooth sprocket for the Honda. This would be a deal breaker for me as the 11 tooth freewheel sprocket is unreliable.
Reply With Quote