View Single Post
Old 04-18-2010, 12:31 AM
AaronF's Avatar
AaronF AaronF is offline
Motorized Bicycle Elite Member
Join Date: Aug 2009
Location: Illinois
Posts: 389
Default Re: Need help with some direction.

For the rear mount block you could take a drill and a 1" drum sander and run it through the block until you get a flush fit on the seat tube.DO Not over sand it or sand it down to the bridge,there isn't much material to remove and I'm not sure how well the bridge of a block mount would hold up to these motors.
Reply With Quote