Thread: Crack in Carb
View Single Post
Old 06-29-2008, 01:09 PM
MarcPhotoMan MarcPhotoMan is offline
Motorized Bicycle Elite Member
Join Date: May 2008
Location: Montreal, Canada
Posts: 258
Default Re: Crack in Carb

Ok so as many of you know I have been chasing a very small vapor leak. After sealing up the cracks in my carb, which i could only find via my digital camera and photoshop and lot of evidence that someone tryed to fix it before i even owned it.

Just venting a little

Any way I think it's fixed thanks to JB Weld.

but now it is Idling high, I have to screw the idle screw all the way in the idle become lower, when i let the screw out the idle is higher.

I am 100 feet above sea level and it is on the needle second from the top.

Yes i did test with wd40 and it does not stall,

Just one question when you say bog down you mean the idle would change and almost stall?
Attached Images
File Type: jpg inside damagte.jpg (51.0 KB, 28 views)
File Type: jpg Level Enough.jpg (79.9 KB, 30 views)
File Type: jpg who did this.jpg (91.2 KB, 30 views)
Reply With Quote