View Single Post
Old 06-25-2008, 04:41 PM
Bikeguy Joe Bikeguy Joe is offline
Godfather of Motorized Bicycles
Join Date: Jan 2008
Location: up north now
Posts: 11,531
Default Re: Clutch lever, cable & assembly

Originally Posted by tibim View Post
What did you use to lengthen it? Is this the only way to make it easier to engage?

Make sure your cable has no sharp bends in it.
Adjust the cable holder (where the cable housing ends at the engine) on the engine so it lines up with the clutch arm and lock down the locknut..
Oil the cable with some motor oil and slide it back in the outer part.
A bit of oil or grease inside the clutch arm/pushrod will help too.

I've never run anything but the stock cable and lever.

Last edited by Bikeguy Joe; 06-25-2008 at 04:44 PM.
Reply With Quote