View Single Post
Old 03-14-2010, 10:07 AM
kla63's Avatar
kla63 kla63 is offline
Motorized Bicycle Elite Member
Join Date: Jul 2009
Posts: 111
Default Re: Mounting for a Huffy Cranbrook?

Originally Posted by darrick View Post
To all vintage Cranbrook owners!!
I need help with measurements for replacement parts
what measurement front fork is needed for a 26" (?70's-80's?) model?? i want to add suspension forks
also what diameter seatpost are you all using? 25mm-ish?
And where can I find the part that loops/clamps around the handle bars? mine slips randomly when tightened and my handlebars fell causing a pretty bad fall last weekend..tore my knee open

my setup

you can cut some pieces fro an old inner tube!!!!! just about any handle bar neck will fit your bike !!! hope this help, good luck with safer rides!!! there is someone always here too help with all your needs!!!!gas bicycle motors Home

...and the carnage

Help with the above would be nice so I can get back to riding safely.

and on the topic of mounting
where can I find dampening rubber mounts for the motor? wanna reduce any excess vibration I can right now.
you can make them out of a inner tube you might have laying around!!!! just about any fork neck will fit !!!!
Reply With Quote