New Street Sweeper Fenders

michaelgrav

New Member
See what you guys think of these new feners I just installed along with the CNS Carb!
 

Attachments

  • Upload 2.jpg
    Upload 2.jpg
    1 MB · Views: 487
  • Upload 1.jpg
    Upload 1.jpg
    1.1 MB · Views: 707
There's a large air space between the top of the tires & both fenders & no space at the rear... Can you fix it to have the same gap all the way around?
 
Last edited:
I like 'em. They look real good on that bike. Are they steel? Keep a close watch on the mounts, especially the front one. Front fenders can cause some trouble if they come loose and wrap around your wheel.
Tom
 
I'm using some on my build also. Nirve Street Sweepers.
 

Attachments

  • 100_1354.jpg
    100_1354.jpg
    85.4 KB · Views: 689
Last edited:
nice, fenders. don't care much for the struts, but...

red, i like the way you chopped the rear to fit the caliper brake on.

(edit) Hey!, i just noticed, there's no motor on that bike! what's up red?!!!
 
Do you guys see how Reds fenders have a nice even gap between the tire & fender??
That's what I'm talking about!!! (^)
It's the little things like that, that make a few bike builders stand above the rest!

(But I would like the fender to go all the way to the kickstand) ;)
 
Last edited:
What brand of bike is that? I really like the look!
I see after I enlarged the picture. What Nirve model is it?
Steve M.
 
No....no motor yet. Its in the garage though. I've been working (ordering) this bike piece by piece. The motor mount clamps should be here today. They'll have a cleaner look than my usual muffler clamps.
Buggy Billet Alum. Accessories - Page 1
The frame is not a Nirve and not quite the same as a Greenline. This is where I purchased it.
26? Fantasy Cruiser Frame
The fenders are a bit too wide to pass through the caliper brake but.... in that position they "Sweep" around matching the front..
I'll start a new thread when the build is complete.
 
Last edited:
I like the way they look on your bike. I was thinking fenders like those would look good on mine. The problem is, when edward biknut hands is yanking the throttle, the fender stays only last about one week.
 
Back
Top