Re: Slow going...
Looking good jbones! I actually ordered a couple of those billet mounts (1 1/2, and 1 1/4) for my engine mount. I'm going to make a plate to bolt to the mount, then to the engine. It should work better than it looks! It will be similar to the SBC over-sized mount kit, but without the "bend" in it. No drilling through the frame either. Hardware stores, or hobby shops sell aluminum sheets. I picked up my 1/4' sheet for $14.99. cut to size, drill your holes, and yer done! I think I'm going to use 2 clamps, side by side for that extra support. We all gotta meet up and go cruising sometime soon! I've been cruising my old huffy solo for the last 2 years or so. This year is gunna be way better though. Chicago's south-side is about to come alive with motor-bicyclists!