View Single Post
Old 01-26-2010, 10:00 AM
azbill's Avatar
azbill azbill is offline
Motorized Bicycle Elite Member
Join Date: May 2008
Location: Fountain Hills, Arizona
Posts: 3,356
Default Re: drill your own sprocket?

all I did was cut the 9 hole pattern from hole to hole with a grinder
then centered the rotor (160mm) on the sprocket and marked the holes
I found the disc mount was to far out and wouldn't line up with engine sprocket
it is spaced closer to spokes with 2 nuts (I used washers until I got the spacing figured out)
Attached Images
File Type: jpg mini-EZ Motorbike sprocket mount close-up.jpg (177.5 KB, 92 views)

Intelligence is learning from your own mistakes,
Wisdom is learning from the mistakes of others

EZ Motorbike Dealer - Fountain Hills, AZ
EZ Motorbike of Fountain Hills
Reply With Quote