View Single Post
Old 01-09-2010, 09:02 PM
exavid exavid is offline
Motorized Bicycle Elite Member
Join Date: Dec 2009
Location: Medford, OR
Posts: 163
Default Re: how i made an extended front motor mount

I had to extend the front mount on my bike too, I used the extra motor mount section which added about an inch and a quarter or so. I double nutted the front mounting studs and removed them and replaced them with a piece of 6mm all thread I purchased at Ace Hardware. Just double nut them and screw them in. I used a die grinder (could have been a hacksaw) to cut off the excess length. I've replaced all the nuts on the installation with elastic stop nuts except for areas that get hot such as the exhaust and intake manifold.
Reply With Quote