View Single Post
Old 01-25-2008, 10:50 PM
Norman's Avatar
Norman Norman is offline
LORD VADER Moderator
Join Date: Jan 2008
Location: pampa texas
Posts: 2,606
Default Re: Engine top end rebuild and an engine stand

after all lapping gringing etc. clean with warm soap and water.

this is one way to make a pattern for a gasket I'm using the studs to hold the paper in place which is computer paper and then I rub my grubby fingers on the paper transfering the grunge on to the paper.

explains itself

as you can see this is one way to make a pattern and not use a ball peen hammer and risk damaging something

Last edited by Norman; 01-26-2008 at 11:06 AM.
Reply With Quote