View Single Post
Old 12-31-2009, 05:02 AM
chopperjoe's Avatar
chopperjoe chopperjoe is offline
Motorized Bicycle Elite Member
Join Date: Nov 2009
Location: bourbonnais il
Posts: 130
Default Re: Just finished install of 48cc Skyhawk

hello newbee, take the bowl off the bottom of carb,(2 phillips screws) check the little white float to see if it is filled with gas.I had the same issue with my Grubee, also make sure you close the petcock when not running engine. and please change that cheap fuel line with some black rubber line. If float has a leak it should be under warranty, i was sent 2 new ones, but they took their time. (Kings Motorbikes). While you have the bowl off check tightness on the brass main jet that goes that goes through center of float. Also replace that junk plug boot, with anything else that has a snap fit, it simply unscrews from end of wire. Have fun and good luck, you found the right website. Its all here. Chopper joe

Last edited by chopperjoe; 12-31-2009 at 05:11 AM.
Reply With Quote