Thread: reconfigured
View Single Post
Old 12-30-2009, 01:38 PM
bbassfisher bbassfisher is offline
Motorized Bicycle Member
Join Date: Oct 2008
Location: treasure coast fla.
Posts: 29
Default Re: reconfigured

Hello Pablo,
Hopefully this shot shows the side idler plate I had originaly cobbled up to allow the chain to reach the front chain ring. It worked with the original 6speed and derailer, but does not work for some strange reason with a 3 speed rear hub an 4 inch wide tire/rim. I have tried to "reconfigure" my original set up and am becoming frustrated from re-egineering.

Would it be possible to make availiable some new plates to drop the jackshaft r/s drive gear down far enough to clear the bottom of the clutch housing for a direct shot to the chainring?
I am talking about an inch to inch and a half.

Might be an option for others in a simular predicament. "Jackshaft kit for extended frames or choppers with chain ring forward".

Thanks for your input.
Bobby Bass

Attached Images
File Type: jpg bobs chopp bike side 2.JPG (178.9 KB, 48 views)
File Type: jpg bobs chopper front L 3a.JPG (66.3 KB, 38 views)

Last edited by bbassfisher; 12-30-2009 at 01:43 PM. Reason: more pictures
Reply With Quote