View Single Post
Old 12-20-2009, 09:48 AM
wes's Avatar
wes wes is offline
Motorized Bicycle Elite Member
Join Date: Aug 2009
Location: Tucson Az
Posts: 207
Default Re: Running for the 1st time

there is a whole thread on peoples opinion for proper break in prcedures, you might check it out, there is a primer on the left side of the carberator, it is a little plunger, push it in for a couple seconds and you will se the fuel flow down the line and into the float bowl, after that give everything a once over and i usually ride down the rode and check chain tension and roll and so on before i ever pop the clutch, take your time a be patient so that you dont miss anything, Good luck Evan, and welcome to the Forumn!!!
Reply With Quote