View Single Post
Old 12-14-2009, 08:31 AM
Riding Rich Riding Rich is offline
Join Date: Aug 2009
Location: pa
Posts: 349
Default Re: Zoom Gears Not Aligned

I did notice a few washers on the crank when i took mine apart.
No rubbing issues anywhere though.

My primary drive gear is offset a little right of the clutch gear.

What exactlly is rubbing the flywheel is inside the crankcase?

The clutch shaft "Countershaft" should be shimable.
Put an indicator on the end of the shaft and measure the side to side movement.
That measurement is prolly the most you could offset it.
It would have to be shimed inside the Case.

Other than that i think you could use some shims to space the gears out some.
But the shaft and bore of the gears are tapered for a press fit.

I'll have to go over some of my pics and see if i could figure a way to shim things.
Reply With Quote