Thanks for all that filestyle. Im am new too all all this stuff. But that day I was going on a long ride and did a full inspection of the bike before I left. I didnt run it too hard through the 16 mile ride.
I havent checked the electrical parts since I put it together.
I fixed the chain but I didnt use the master link. I just used a cheap chain breaker from walmart (Dont waste your money it broke within ten minutes) to slide the pin right in. Should I use a master link??
Anyway. It runs but At very slow speeds I get the Julting back and forth motion and also when I go over 25mph. I just put a new NGK B6HS. I lowered the need. c clip is one down from the top and im running 32:1.