View Single Post
Old 11-08-2009, 09:56 PM
Kevron99's Avatar
Kevron99 Kevron99 is offline
Motorized Bicycle Elite Member
Join Date: Aug 2009
Location: Howell, New Jersey
Posts: 261
Default Re: SBP"s exhaust chamber upright position

Originally Posted by toker_ace View Post
I made my pipe in the upright position.I needed a piece of copper in the 45 degree without one end flanged.So i cut a piece out of an old set of handlebars. I also went to tractor supply and bought a $3.00 muffler and bored out the end a little and it slide right onto the silencer of the pipe.Drilled a whole and put a small bolt on. It did help with the popping noise these pipe's make.Its still a little loud but better.I was going to get some header wrap but its like $30.00. Any ideas on me not burning my leg?LOL!
Nice looking exhaust you got there...I have the same set up before but I decided to bring the SBP mufflers down because of heat towards my leg even if you have header wrapped the mufflers. Anyway here is a good wrap for your set up...BTW your plugs will burn if you have the mufflers too close...

Header Wrap Black-Fiberglass 50Ft~ Free Metal Zip Ties!:eBay Motors (item 200400713721 end time Nov-11-09 01:08:16 PST)
Reply With Quote