View Single Post
Old 11-08-2009, 11:32 AM
toker_ace's Avatar
toker_ace toker_ace is offline
Motorized Bicycle Elite Member
Join Date: Oct 2008
Location: alabama
Posts: 465
Default SBP"s exhaust chamber upright position

I made my pipe in the upright position.I needed a piece of copper in the 45 degree without one end flanged.So i cut a piece out of an old set of handlebars. I also went to tractor supply and bought a $3.00 muffler and bored out the end a little and it slide right onto the silencer of the pipe.Drilled a whole and put a small bolt on. It did help with the popping noise these pipe's make.Its still a little loud but better.I was going to get some header wrap but its like $30.00. Any ideas on me not burning my leg?LOL!
Attached Images
File Type: jpg upright muffler.JPG (132.3 KB, 169 views)
File Type: jpg upright upclose.JPG (117.3 KB, 135 views)
Reply With Quote