View Single Post
Old 11-07-2009, 12:13 AM
bseelbach bseelbach is offline
Motorized Bicycle Elite Member
Join Date: Jul 2009
Location: USA
Posts: 136
Default Re: Good Throttle + cable

No- I couldn't figure out what threads were on the throttle assembly and the supplier offered little help. I ended up using a dremmel to virtually remove the 'threads' on the inside of of the throttle housing to make a press fit for an adjuster screw.

Go slow and you should be fine. Adjuster screws come in two diameter sizes from local bike shops. Aim for the smaller diameter and settle for the larger if you grind too much.

Stock throttle cable is the wrong length for the thumb throttle. I followed Norms post but I think after I I hooked it up to the thumb throttle and left in a neutral position, I made the other end 49mm off from the cable housing.
Reply With Quote